KYOCERA S-9100DN Uživatelský manuál stáhnout pdf (Strana 99)

Appendix C Host Computer Interface

C-5

The Properties sheet is displayed for the selected

COM port. Click on the Port Settings tab and set the

port properties.

After setting the properties, click the OK button.





 DOS

Enter the following commands:

C:\>MODE COM1:96,N,8,1,P

C:\>MODE LPT1:=COM1

To test the interface, enter the following:

CTRL P

C:\>DIR

CTRL P

The software settings made using the above procedures are

temporary. On most computers, permanent settings must be

made with DIP switches.

If you want to use a different baud rate or change any of the other

RS-232C parameters, this can be accomplished from the print-

er’s operator panel. See Changing the Interface Parameters on

page 3-18.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 142 143

Žádné komentáře

KYOCERA S-9100DN Uživatelský manuál Strana 99